Performing a Successful Water Heater Flush
Steps To Perform A Flush For A Water Heater
Performing a successful water heater flush is an excellent way to help maintain your device and prevent unnecessary damage or repairs. The process is very simple, even if you don't have any prior plumbing experience. Follow the steps below to perform a flush for the water heater in your home in San Antonio, TX.
1. Turn Off the Heater's Power.
This process varies depending on whether you have a gas or electric models. For a gas model, simply extinguish the pilot light. If you have an electric model, turn off the line in the circuit box that supplies the heater.
2. Designate a Proper Drainage Area and Connect the Hose.
You need to designate an area where you can drain the water. It should be a spot that can handle lots of warm water flow, without running the risk of flooding your property. Connect one end of your garden hose to the drain valve before running the opposite end of the hose into your designated drainage area.
3. Drain Your Tank.
Open your drain valve to let the water out. Allow it to flow for several minutes. During this time, head into your kitchen and turn on the hot water faucet in the sink. This helps the water run more smoothly. After a few minutes, shut off the supply valve. The water flow will gradually begin to slow before it stops altogether. Reopen the drain valve to perform one more quick flush before shutting it off again.
4. Refill the Tank.
Close the valves and turn the water supply back on. Keep an eye on the faucet in your kitchen. Once the water starts running smoothly, you'll know that the heater's tank is full.
5. Reactivate the Heating Element.
Refer to step one to reactivate the power in your heater. You have now performed a successful water heater flush.
Proper water heater maintenance is essential if you wish to keep your device running properly for a long time. For more assistance or information, contact water remediation experts.